Cart
0
FS Labs · Research Protocol
How To Use
Your Peptide Pen
Follow these steps carefully for safe and accurate preparation. For research use only.
Step by Step
Preparation Protocol
01
Check The Product
Inspect the pen before use. Check the expiry date, ensure the solution is clear, and confirm the packaging is intact and undamaged.
Inspection
02
Remove From Fridge
Take the pen out of the refrigerator (2–8°C). Allow it to reach room temperature for a few minutes before use for comfort.
Preparation
03
Attach The Needle
Attach a new sterile needle tip to the pen. Twist firmly until it is securely locked in place. Never reuse needles.
Assembly
04
Activate The Solution
Remove the protective cap and turn the dial until point C. This fully activates the peptide solution and prepares it for injection.
Activation
05
Gently Invert
Turn the pen top-to-bottom and bottom-to-top repeatedly until fully mixed. Solution should be clear with no visible powder. Do not shake.
Mixing
06
Remove Needle Protector
Pull the needle protector straight up to remove it. Prime the pen until a small drop appears at the tip to remove any air bubbles.
Priming
07
Inject Subcutaneously
Insert at 90° into subcutaneous tissue. Common sites include lower abdomen, upper thigh, or outer upper arm. Rotate injection sites regularly.
Injection
08
Hold Then Remove
Hold the pen in place for 10 seconds after injection to ensure full delivery of the dose. Then remove the needle smoothly and straight.
10 Seconds
09
Dispose And Store
Remove and safely dispose of the used needle in a sharps container. Replace the cap and store the pen refrigerated at 2–8°C.
Storage
Research Use Only
All FS Labs products are strictly for laboratory research purposes only. Not intended for human or veterinary consumption, medical use, diagnosis, treatment, or prevention of any disease. Use outside research purposes should only occur under the direction of a qualified healthcare professional where legally permitted.